![]() ![]() Plot the measurements (saved on the SD card) on your PC using Matlab or Python. Could not find a ready solution for using 1-wire protocol with STM32 in C (working wiwth IAR), so I decided to rework the C++ library that came with arduino. Arduino library for Maxim DS2431 1-Wire EEPROM Requires OneWire library to work. This I2C digital temperature sensor is one of the more accurate/precise. This code essentially calls upon the Arduino library, 'OneWire', and takes the serial data taken from the sensor, and further modifies/converts the incoming data into a readable, decimal value. Raise an alarm if a measurement gets outside the range (below or above), I am using the Adafruit-MCP23017-Arduino-Library for my project GitHub GitHub. Use Arduino to acquire two signals from two different sensors, DallasTemperature sensors ( & oneWire ) /* How To Program For DS18B20 Temperature Sensor. ![]() Setup a oneWire instance to communicate with any OneWire devices (not just Maxim/Dallas temperature ICs) OneWire oneWire ( ONE_WIRE_BUS ) // Pass our oneWire reference to Dallas Temperature. The adapter has a built-in resistor, eliminating the need for a separate one in the wiring. Data wire is plugged into port 2 on the Arduino #define ONE_WIRE_BUS 2 Include the libraries we need #include ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |